GAUGE CUTTER

TUBING GAUGE / PARAFFIN CUTTER

TUBING GAUGE / PARAFFIN CUTTER

The ACT Tubing Gauge / Paraffin Cutter is run in the hole before running any sub surface equipment. The tubing gauge / paraffin cutter is used to check if there are any obstruction to passage of the sub surface equipment. The bottom of tubing gauge / paraffin cutter is suitable to cut paraffin, scale or other obstacles in the tubing.

Selection of size :

Example:

Nipple bore = 2.25″ No Go ID = 2.197″

The tubbing gauge cutter should be between these two sizes.

*Tubing Gauge / Paraffin Cutters are also available in MM. increments within the specified

O.D. ranges. When ordering , specify the required O.D. in MM ( Inches x 25.4 = MM)

TUBING GAUGE / PARAFFIN  CUTTER
O.D. Range (in) * F/N O.D.(in) Top Connection Part No.
0.905 - 1.575 0.875 5/8 - 11 UNC 831600
1.655 - 2.265 1.375 15/16 - 10 UN 832231
2.323 - 2.520 1.375 15/16 - 10 UN 832521
2.598 - 2.953 1.750 1-1/16 - 10 UN 832932
2.992 - 3.900 2.312 1-1/16 - 10 UN 833942
5.750 - 6.151 2.312 1-9/16 - 10 UN 836146

TUBING GAUGE CUTTER RING SET

TUBING GAUGE CUTTER RING SET

The ACT Gauge Cutter Ring Set is a wireline service tool designed to operate as a standard gauge cutter, but with the added facility of being able to interchange different size gauge cutters on a standard carrier.

ACT gauge cutter ring set is of primary benefit where an operation requires a number of gauge cutters of diameter in a size range. This flexibility means that there is no need to keep a large inventory of different size gauge cutters.

TUBING GAUGE CUTTER RING SET
Size Range (in) Fishneck O.D. (in) Top Connection Part No.
1.0 - 1.5 1.187 15/16 - 10UN 83-150-00
1.5 - 3.0 1.375 15/16 - 10UN 83-300-00
3.0 - 6.0 1.750 1-1/16 - 10UN 83-600-00